You will need a soldering iron for this (we will soon be adding soldering irons here) but it's a pretty simple job.

I hope to have some detailed instructions on the fitting of a standard PL259 coax plug here soon. Until then, we can supply the end of the cable prepared so that you can see how it's done and recreate a fresh end the same - if necessary.

Click here to tell us that you want your dome mount lead supplied without the PL259 plug fitted

In most cases it's probably best that we do the DV plug (aerial end) as these can be a bit tricky if you're not used to doing them - especially with the RG8 cable. However, if you really need this end to be unfitted you can Click Here to tell us.

You will need a soldering iron for this (we will soon be adding soldering irons here) but it's a pretty simple job.

I hope to have some detailed instructions on the fitting of a standard PL259 coax plug here soon. Until then, we can supply the end of the cable prepared so that you can see how it's done and recreate a fresh end the same - if necessary.

Click here to tell us that you want your stud mount lead supplied without the plug fitted

A PSM-1 lead has a normal PL259 plug on one end (to go into the CB), and ring connectors to connect to the PSM-1 mount on the other.

The PL259 plug will need soldering (we will soon be adding soldering irons here) but it's a pretty simple job.

The ring connectors need crimping on ideally with the correct tool, although careful use of pliers or grips may be satisfactory - in this case i advise soldering as well.

I hope to have some detailed instructions on the fitting of a standard PL259 coax plug here soon. Until then, we can supply the end of the cable prepared so that you can see how it's done and recreate a fresh end the same - if necessary.

Click here to tell us that you want your PSM-1 mount lead supplied without the PL259 PLUG fitted

Alternatively...

Click here to tell us that you want your PSM-1 mount lead supplied without the RING CONNECTORS fitted

You can login at any time to change or add to your listing, and of course it's totally free.

The only requirement is that you should have a link back to us.

If you have a links page already, simply add us to that, preferably with one of our link images below. If you do not have images for your links, please try to make sure you mention the fact that we are based in the UK.

If you don't have a links page, perhaps you could still use an image - somewhere on your homepage for example - i have produced a number of smaller images that might suit you, these are only 1.1k in size!